Type: disk
Protocol: SAS (SPL-3)
Model: ST2000NM0023
Family: none
Serial: Z1X0GL680000C4013P13
R Rate: 7200 rpm
Size Smart: 2.00 TB
Size:
Firmware:
Active: 1

smartctl 6.6 2016-05-31 r4324 [x86_64-linux-4.15.0-20-generic] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Vendor: SEAGATE
Product: ST2000NM0023
Revision: 0003
Compliance: SPC-4
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Logical block size: 512 bytes
LU is fully provisioned
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Logical Unit id: 0x5000c50056ed0283
Serial number: Z1X0GL680000C4013P13
Device type: disk
Transport protocol: SAS (SPL-3)
Local Time is: Thu Oct 11 01:30:11 2018 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Enabled

=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK

Current Drive Temperature: 32 C
Drive Trip Temperature: 40 C

Manufactured in week 28 of year 2013
Specified cycle count over device lifetime: 10000
Accumulated start-stop cycles: 67
Specified load-unload count over device lifetime: 300000
Accumulated load-unload cycles: 1774
Elements in grown defect list: 0

Vendor (Seagate) cache information
Blocks sent to initiator = 1183105237
Blocks received from initiator = 182454000
Blocks read from cache and sent to initiator = 1443474
Number of read and write commands whose size <= segment size = 1090744
Number of read and write commands whose size > segment size = 41885

Vendor (Seagate/Hitachi) factory information
number of hours powered up = 40939.97
number of minutes until next internal SMART test = 51

Error counter log:
Errors Corrected by Total Correction Gigabytes Total
ECC rereads/ errors algorithm processed uncorrected
fast | delayed rewrites corrected invocations [10^9 bytes] errors
read: 705571504 0 0 705571504 0 57913.499 0
write: 0 0 0 0 0 112248.067 0
verify: 15360 0 0 15360 0 0.000 0

Non-medium error count: 2


[GLTSD (Global Logging Target Save Disable) set. Enable Save with '-S on']
No self-tests have been logged